Find Out More About The Unrivaled A/T Optic Mount
Improving on Mil-Spec rail interfaces dating back over 30 years, the BCM A/T mount delivers an unprecedented zero retention on a properly mounted red dot optic.
![BCM A/T mount](https://airsoftmilsimnews.com/wp-content/uploads/2024/05/unnamed-18-1-932x1024.jpg)
Low profile and snag-free, BCM A/T Mounts are built with a minimal number of components and 7075T6 aluminum- delivering a stronger component with less points of failure, ready to take on dynamic and adverse settings. With an equivalent load applied, the A/T Mount delivers approximately twice the clamping force at the picatinny rail, versus a legacy horizontal interface.
![BCM A/T mount](https://airsoftmilsimnews.com/wp-content/uploads/2024/05/unnamed-19-1024x453.jpg)
A/T (Angled Torque) mounts employ angled torque through a patented clamp which applies triangulating force to create a stronger and more reliable lock up of the mount onto the end user’s rail.
To retain the hardware in field conditions, this system uses a serrated locking spring-washer to prevent the loss of torque on the shaft nut.
With an equivalent load applied, the A/T Mount delivers approximately twice the clamping force at the picatinny rail, versus a legacy horizontal interface.